Kyocera FS-C5350DN Advanced Operation Manual page 75

>>Bonjour
? Off
>TCP/IP (IPv6) >
? Off
Using the Operation Panel
5
Display the desired gateway and press [OK].
6
Press [MENU]. The display returns to Ready.
Bonjour (Bonjour setting)
Bonjour, also known as zero-configuration networking, is a service that
automatically detects computers, devices and services on an IP network.
Bonjour, because an industry-standard IP protocol is used, allows
devices to automatically recognize each other without an IP address
being specified or DNS server being set.
Bonjour also sends and receives network packets by UDP port 5353. If a
firewall is enabled, the user must check that UDP port 5353 is left open
so that Bonjour will run correctly. Some firewalls are set up so as to reject
only certain Bonjour packets. If Bonjour does not run stably, check the
firewall settings and ensure that Bonjour is registered on the exceptions
list and that Bonjour packets are accepted. If you install Bonjour on
Windows XP Service Pack 2 or later, the Windows firewall will be set up
correctly for Bonjour.
1
Press while >TCP/IP
2
Press or repeatedly until >>Bonjour appears.
3
Press [OK]. A blinking cursor (_) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
TCP/IP (IPv6) (IPv6 settings)
This selects the settings for TCP/IP (IPv6).
TCP/IP (IPv6) is based on the current Internet protocol, TCP/IP (IPv4).
IPv6 is the next-generation Internet protocol and expands the available
address space, which resolves the problem of the lack of addresses
under IPv4, while also introducing other improvements such as additional
security functionality and the capacity to prioritize data transmission.
The options available in the TCP/IP (IPv6) settings are as follows:
• RA(Stateless) (RA (Stateless) setting)
• DHCPv6 (DHCPv6 setting)
IMPORTANT The RA (Stateless) and DHCPv6 menu options for TCP/
IP (IPv6) are displayed when TCP/IP (IPv6) is enabled.
1
Press while Network > is displayed.
2
Press or repeatedly until >TCP/IP (IPv6) > appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Select On and press [OK].The display changes to the settings shown
below.
On > is displayed.
or .
or .
2-51