Gigabyte GA-990FXA-UD3 User Manual page 76

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Make sure OnChip SATA Controller is enabled. To enable RAID for the SATA3_0/1/2/3 connectors, set On-
Chip SATA Type to RAID. To enable RAID for the SATA3_4/5 connectors, set OnChip SATA Type to RAID
and set OnChip SATA Port4/5 Type to As SATA Type (Figure 1). To enable support for RAID 5, set OnChip
SATA RAID5 Support to Enabled.
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
OnChip SATA Controller
OnChip SATA Type
OnChip SATA Port4/5 Type
OnChip SATA RAID5 Support
OnChip SATA3.0 Support
x OnChip SATA Port as ESP
F_USB30 Controller
eSATA3 Controller
eSATA3 Ctrl Mode
Onboard LAN Function
Onboard LAN Boot ROM
 SMART LAN
Onboard Audio Function
Onboard 1394 Function
R_USB30 Controller
USB Controllers
USB Legacy Function
USB Storage Function
Onboard Serial Port 1
higf: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Appendix
Integrated Peripherals
[Enabled]
[RAID]
[As SATA Type]
[Enabled]
[Enabled]
Press Enter
[Enabled]
[Enabled]
[IDE]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 76 -
Item Help
Menu Level 
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults