Setting Up Amd Crossfirex ™ Configuration - Gigabyte GA-990FXA-UD3 User Manual

1-6 Setting up AMD CrossFireX
A. System Requirements
- Windows 7, Windows Vista or Windows XP operating system
- A CrossFireX-supported motherboard with two PCI Express x16 slots and correct driver
- Two CrossFireX-ready graphics cards of identical brand and chip and correct driver
- CrossFireX bridge connector(s)
- A power supply with sufficient power is recommended (Refer to the manual of your graphics cards for
the power requirement)
B. Connecting the Graphics Cards
Step 1:
Observe the steps in "1-5 Installing an Expansion Card" and install two CrossFireX graphics cards on the
PCIEX16_1 and PCIEX16_2 slots.
Step 2:
Insert the CrossFireX bridge connector(s)
cards.
Step 3:
Plug the display cable into the graphics card on the PCIEX16_1 slot.
C. Configuring the Graphics Card Driver
To Enable CrossFireX Function:
After installing the graphics card driver in the operating system, go to the Cata-
lyst Control Center. Browse to Performance\AMD CrossFireX Configura-
tions and ensure the Enable CrossFireX
Apply.
(Note) The bridge connector(s) may be needed or not depending on your graphics cards.
Procedure and driver screen for enabling CrossFireX technology may differ by graphics cards and
driver version. Refer to the manual that came with your graphics cards for more information about
enabling CrossFireX technology.
Configuration
™
(Note)
in the CrossFireX gold edge connectors on top of the two
(Note)
check box is selected and click
™
- 19 - Hardware Installation