INTEGRATOR'S NOTE
Use only ATX12V-compliant power supplies.
For information about
Power supply connectors
1.5
System Memory
The board has two DIMM sockets and supports the following memory features:
•
1.5 V DDR3 SDRAM DIMMs with gold plated contacts, with the option to raise the
voltage to support higher performance DDR3 SDRAM DIMMs
•
Dual channel interleaved mode support
•
Unbuffered, single-sided or double-sided DIMMs with the following restriction:
Double-sided DIMMs with x16 organization are not supported.
•
4 GB maximum total system memory (with two 2 GB DIMMs). Refer to
Section 2.1.1 on page 37 for information on the total amount of addressable
memory.
•
Minimum total system memory: 512 MB
•
Non-ECC DIMMs
•
Serial Presence Detect
•
DDR3 800 MHz, DDR3 1066 MHz, and DDR3 1333 (overclocking required) MHz
SDRAM DIMMs
Note: DDR3-1333 memory operates at 1066 MHz by default until manually
overclocked through the system BIOS.
CAUTION
Altering PC memory frequency, voltage and/or latency may: (i) reduce
system stability and useful life of the system, memory and processor;
(ii) cause the processor and other system components to fail; (iii) cause
reductions in system performance; (iv) cause additional heat or other
damage; and (v) affect system data integrity. Intel has not tested, and does
not warranty, the operation of the memory beyond its specifications. Intel
assumes no responsibility that the memory, including if used with altered
clock frequencies and/or voltages, will be fit for any particular purpose.
Check with the memory manufacturer for warranty and additional details.
Product Description
Refer to
Section 2.2.2.4, page 46
15