Zenith L26W56S Installation And Operating Manual page 42

Cloning Connections / Teaching Setup
Teaching the Master Setup to Another L26W56X
Connections for the LT2002 to Teach another L26W56X the Master Setup
Antenna
or CATV
Teach Master L26W56X's Setup to the target
L26W56X
After learning is complete, remove the M.P.I. cable from the
master L26W56X and connect it to the target L26W56X that you
want to copy the master L26W56X's setup into. With "THE
CLONE HAS CONTROL OF TV" message displayed, press 2 to go to
the "TEACH TO TV" option, press ON/OFF, POWER, or ENTER.
Select the LT2002 memory that the new setup is in. Press
On/Off to transfer the new setup and other information to the
new L26W56X. Teaching usually takes 2-3 minutes.
After the "TEACHING COMPLETE" message is displayed, press any
key to return to the Clone menu, then press ON/OFF, POWER, or
ENTER. If finished, detach M.P.I. cable from the target, newly
cloned L26W56X.
Disconnect L26W56X Power for 5 Seconds
Unplug the AC power cord of the newly cloned L26W56X from
the power outlet for about 5 seconds to activate the newly-
copied setup.
P A G E 4 2
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
Master L26W56X
Ferrite Core
(TDK, ZCAT
2035-0930)
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
- TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
- TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER
This menu should appear after any key is
pressed on the Installer remote.
TEACHING IN PROGRESS,
PLEASE WAIT
This display will appear during Teaching
function.
TEACHING COMPLETE
This display will appear after Teaching is
complete.
¤
QuickSet II Programmer
LT2002
Clone Programmer