Assembling And Hanging The Fan - Hunter 28670 Owner's Manual

WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angled mounting:
3-2. Insert the downrod through the canopy and canopy trim ring.
Feed the wires from the fan through the downrod on one side of
the pin in the ball.
3-3. Loosen the square head setscrew on the adapter to install the pipe
and ball assembly. Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal.
Securely retighten the setscrew with a wrench or pliers. Skip to
step 3-7.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the
low profile washer.
3-4. Remove the setscrew from the adapter.
3-5. Place the low profile washer into the canopy with the lip down.
3-6. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
Hanging the Fan:
Note: To hang the fan, you must tilt the canopy to an almost vertical
position so that the canopy slots sit on the ceiling plate hooks.
3-7. Raise the fan and align the slots in the canopy with the hooks on
the ceiling plate.
3-8. Place the slots over the hooks to hang the fan.
3 • Assembling and Hanging the Fan
8
42433-01 • 01/19/11 • Hunter Fan Company
Standard or Angled Mounting
Steps 3-2 – 3-3
Setscrew
Low Profile Mounting
Steps 3-5 – 3-6
Low Profile Screws
Green
Ground
Wire
Canopy
Trim Ring
Low Profile Screw
Step 3-6 (Detail)
Low Profile Screw
Adapter
Downrod
Canopy
Canopy
Trim Ring
Low Profile
Washer
Canopy
Low Profile
Washer