Asus MAXIMUS IV EXTREME-Z User Manual page 64

3. Marvell
(7-pin SATA6G_E1/E2 [red])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
•
•
•
•
•
2-32
Serial ATA 6.0 Gb/s connectors
®
The SATA6G�E1/E2 (red) connectors are for data drives only.
You must install Windows
Serial ATA hard disk drives.
When using hot-plug and NCQ, set the Marvell Controller item in the BIOS
to [AHCI Mode]. Refer to section �.�.� Onboard Devices Configuration
for details.
Press <Ctrl> + <M> during POST to enter the Marvell RAID utility to create
or delete a RAID configuration.
If you want to install a Windows operating system to a RAID configuration
created using the Marvell SATA controller, you have to create a RAID driver
disk using the motherboard support DVD and load the driver during OS
installation. For 32/64bit Windows XP OS, load first the Marvell shared
library driver, and then load Marvell 91xx SATA Controller Driver.
For Windows Vista / Windows 7 OS, load only the Marvell 91xx SATA
Controller Driver.
XP Service Pack 3 or later versions before using
®
Chapter 2: Hardware information