GE JV367HWW Owners And Installation Manual page 10

REMOVE EXHAUST ADAPTOR
2
If exhausting/venting using the 3
Set it aside along with its mounting screws.
3
1 4
rectangular
adaptor
and screws
REMOVE FILTER
3
Remove the shipping tape holding the metal grease
filter in place. Pull down on the center of the front edge
of the filter. The filter will then slip out of the retaining
tabs on the back.
Metal grease filter
REVERSE THE BAFFLE FOR
4
DUCTED INSTALLATIONS ONLY
Remove the baffle from the top of the hood. Reinstall
the baffle so the short side marked "VENTED" is visible.
The long side of the baffle should be inside the hood.
"VENTED" is visible
Installation Instructions
x 10 rectangular
1
4
10
REMOVE WIRING COVER
5
Remove the wiring cover from inside the hood.
Set the cover and its mounting screws aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
6
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Back
Top
knockout
knockout
Strain relief
clamp
REMOVE DUCT KNOCKOUT
7
If recirculating, non-vented ductless (JN327 and RN328,
and optional for JV247, JV248, JV347, JV348 and JV367
models only), skip to Step 11 D and proceed.
Using a flat-blade screwdriver, remove the appropriate
duct knockout from the top or back of the hood.
3 x 10 Rectangular
1 4
vertical discharge.
Remove top rectangular
duct knockout only.
Strain relief
clamp
7 Round vertical discharge.
Remove circular duct
knockout only.
3 x 10 Rectangular horizontal
1 4
discharge. Remove rear
rectangular duct knockout only.