Denon AVR-1613 Owner's Manual page 27

Check
12
Use ui to select the item you
want to check, and then press
ENTER .
Audyssey Setup
C heck p roce s s ing r es ult .
To pr oc eed, s el ect "Sto r e".
Speaker Config.
Distances
Levels
Crossovers
Store
• Subwoofers may measure a greater reported distance than
the actual distance due to added electrical delay common in
subwoofers.
BACK
• If you want to check another item, press
NOTE
• If the result differs from the actual connection status, or if "Caution!"
is displayed, see "Error messages" (vpage
Audyssey ® Setup again.
• If you change speaker positions or orientation, perform Audyssey ®
Setup again to find the optimal equalizer settings.
DVD DVD
Store
13
Select "Store" and then press
Save the measurement results.
C h e c k p r o c e s sin g r e s ult .
To p r o c e e d , s e le c t "Sto r e ".
MultEQ
N o w S t o r in g. . .
p le a se wa it. . .
.
25). Then carry out
• Saving the results requires about 10 seconds.
• During saving of measurements results, "Now Storing...Please
wait..." is displayed. When saving is completed, "Storing complete.
Audyssey ® Setup is now finished." is displayed.
NOTE
During saving of measurement results, be sure not to turn off the
power.
ENTER
.
Audyssey Setup
MultEQ
Speaker Config.
Distances
Levels
Crossovers
Store
Audyssey Setup
MultEQ
75%
24
Set up speakers (Audyssey ® Setup)
Finish
14
Unplug the setup microphone from the unit's SETUP
MIC jack.
15
Select "Next" and then press ENTER
16 Set Audyssey Dynamic Volume ® .
Audyssey Setup
Yo u can s et D y namic V o lu me fun c tio n,
wh ic h aut o matic ally adju s ts vo lume level
fo r all c on t en t.
Do you wan t to en able ?
Yes
No
• This feature adjusts the output volume to the optimal level while
constantly monitoring the level of the audio input to the unit.
Optimal volume control is performed automatically without any
loss in the dynamism and clarity of the sound when, for example,
the volume suddenly increases for commercials shown during
television programs.
n When turning Dynamic Volume on
u
• Press to select "Yes", and then press
The unit automatically enters "Medium" (vpage 84) mode.
n When turning Dynamic Volume off
i ENTER
• Press to select "No", and then press
NOTE
After performing Audyssey ® Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey ® Setup again.
.
MultEQ
ENTER
.
.