Dell Vostro 270 Owner's Manual page 44

Error Messages
HARD-DISK DRIVE READ FAILURE
INSERT BOOTABLE MEDIA
INVALID CONFIGURATION INFORMATION-PLEASE RUN
SYSTEM SETUP PROGRAM
KEYBOARD CLOCK LINE FAILURE
KEYBOARD CONTROLLER FAILURE
KEYBOARD DATA LINE FAILURE
KEYBOARD STUCK KEY FAILURE
LICENSED CONTENT IS NOT ACCESSIBLE IN
MEDIADIRECT
MEMORY ADDRESS LINE FAILURE AT ADDRESS, READ
VALUE EXPECTING VALUE
MEMORY ALLOCATION ERROR
MEMORY DOUBLE WORD LOGIC FAILURE AT ADDRESS,
READ VALUE EXPECTING VALUE
44
Description
drive. Run the Hard Disk Drive tests in the Dell
Diagnostics.
The hard drive may be defective. Shut down the computer,
remove the hard drive, and boot the computer from a
optical. Then, shut down the computer, reinstall the hard
drive, and restart the computer. If the problem persists, try
another drive. Run the Hard Disk Drive tests in the Dell
Diagnostics.
The operating system is trying to boot to non-bootable
media, such as a floppy disk or optical drive. Insert
bootable media.
The system configuration information does not match the
hardware configuration. The message is most likely to
occur after a memory module is installed. Correct the
appropriate options in the system setup program.
For external keyboards, check the cable connection. Run
the Keyboard Controller test in the Dell Diagnostics.
For external keyboards, check the cable connection.
Restart the computer, and avoid touching the keyboard or
the mouse during the boot routine. Run the Keyboard
Controller test in the Dell Diagnostics.
For external keyboards, check the cable connection. Run
theKeyboard Controller test in the Dell Diagnostics.
For external keyboards or keypads, check the cable
connection. Restart the computer, and avoid touching the
keyboard or keys during the boot routine. Run the Stuck
Key test in the Dell Diagnostics.
Dell MediaDirect cannot verify the Digital Rights
Management (DRM) restrictions on the file, so the file
cannot be played.
A memory module may be faulty or improperly seated.
Reinstall the memory modules and, if necessary, replace
them.
The software you are attempting to run is conflicting with
the operating system, another program, or a utility. Shut
down the computer, wait 30 seconds, and then restart it.
Try to run the program again. If the error message still
appears, see the software documentation.
A memory module may be faulty or improperly seated.
Reinstall the memory modules and, if necessary, replace
them.