Channel Mode Message; Channel After Touch; Polyphonic After Touch - Yamaha MOX8 Manual

Table 3:
RPN
MSB LSB
000 000
000 001
000 002
127 127
3-2-5

Channel Mode message

All Sounds Off
(Control #120)
Reset All Controllers
(Control #121)
All Notes Off (Control
#123)
Omni Mode Off
(Control #124)
Omni Mode On
(Control #125)
Mono (Control #126)
Poly (Control #127)
3-2-6

Channel After Touch

Messages that let you control the sounds by the pressure you apply to the keys after the initial
striking of the keys, over the entire channel.
3-2-7

Polyphonic After Touch

Messages that let you control the sounds by the pressure you apply to the keys after the initial
striking of the keys, for each individual key.
RPN Parameter List
Parameter Data Entry
Name (Range)
MSB
Pitch Bend 000 - 024 -
Sensitivity
Fine Tune -64 - +63
Coarse Tune -24 - +24
Null -
Clears all sounds currently sounding on the specified channel.
However, the status of channel messages such as Note On and Hold On
is maintained.
Resets all controllers to their initial values.
However, some controllers are not affected.
Clears all notes currently on for the specified channel.
However, if Hold1 or Sostenuto is on, notes will continue sounding until
these are turned off.
Performs the same operation as when an All Notes Off message is
received.
The receive channel is set to 1.
Performs the same operation as when an All Notes Off message is
received.
Only the receive channel is set to Omni On.
Performs the same operation as when an All Sound Off message is
received.
rd
If the 3 byte parameter (the parameter that determines the mono number)
is 0 - 16, the parts corresponding to those channels are set to Mono.
Performs the same function as when an All Sounds Off message is
received.
Sets the corresponding channel to Poly Mode.
Function
LSB
Specifies the amount of pitch bend
produced in response to pitch bend
data in semitone increments.
- Adjusts the tuning in cent increments.
- Adjusts the tuning in semitone
increments.
- Voids the RPN and NRPN settings so
no tone generator settings are
changed when subsequent Data Entry
messages are received.
71
MIDI