Play Mode; Memory Select - Yamaha DX9 Operating Manual

PLAY MODE
€ Playing the Internal Voices
The DX9 has 20 internal voices, any one of which can be
selected simply by pressing the key,
and then by pressing the appropriate Voice Select key.
Each Voice Select key has a large numeral that corresponds
to the voice number at its left edge.
Select and play each voice to get a feel for the kind of
sounds that are available.
EDIT/ MEMORY
COMPARE SELECT
| |] | Press the Memory Select key,
C_F t] set to the Play mode.
REL NEN
Select the
oreset Voice voice number
Display at the Play mode
MEMORY SELECT
MASTER ТИНЕ НОЈ
Display shows the last parameter
at the Function mode.
Fine adjustment of volume while playing can be
achieved using an optional FC-3A foot controller
plugged into the VOLUME jack on the DXO9 rear
panel. Remember that the DX9 and amplifier volume
controls should be set high enough that adequate
volume control range is available using the foot
controller.
Lm
=== = ОС
(FC-3A)
"С
65»
€ Set the desired VOLUME level
With power to the DX9 and your amplifier system ON,
gradually raise the volume control while playing a note on
the keyboard until the desired volume level is reached. Set
the volume contro! on your amplifier so the optimum
volume is attained with the DX9 volume control set at
about 48"
® Playing the External Voices
The voice data contained on the voice data cassette must be
loaded into the instrument before it can be played, Refer to
the "LOAD" section on page 19 for loading instructions.