Yamaha MOX8 Manual page 57

Comp Output Level
Control Type
2-3-4 D
Damper Control
Decay
Delay Level
Delay Level C
Delay Mix
Delay Offset
Delay Time
Delay Time C, L, R
Delay Time L>R
Delay Time Offset R
Delay Time R>L
Delay Transition
Rate
Density
Depth
Detune
Device
Diffusion
Direction
Divide Freq High
Divide Freq Low
Divide Min Level
Determines the level of the signal output from the compressor effect.
This is a parameter of Control Delay.
Normal: The delay effect is always applied to the sound.
Scratch: The delay effect is not applied if both the Delay Time and
Delay Time Offset are set to 0.
When the half-damper compatible FC3 footswitch is connected to the
SUSTAIN jack, the Damper Control parameter is controlled by the FC3
over a range of 0 - 127, allowing for partial damper effects, such as are
available on an actual grand piano.
Controls how the Reverb sound decays.
Determines the level of the delayed sound.
Determines the level of the delayed sound for the center channel.
Determines the level of the delayed mixed sound when multiple effects are
applied.
Determines the offset value of the delay modulation.
Determines the delay of the sound in note value or absolute time.
Determines the delay time for each channel: center, left and right.
Determines the amount of time between the moment the sound is input
from the L channel and the moment the sound is output to the R channel.
Determines the delay time for the R channel as offset.
Determines the amount of time between the moment the sound is input
from the R channel and the moment the sound is output to the L channel.
Determines the speed (rate) at which the delay time is changed from the
current value to the specified new value.
Determines the density of the reverberations or reflections.
Determines a specific value, depending on the selected Effect type.
For Space Simulator, this parameter determines the depth of the simulated
room.
For VCM Flanger, this parameter determines the Amplitude of the LFO
wave that controls the cyclic change of the delay modulation.
For Phaser Type, this parameter determines the Amplitude of the LFO
wave that controls the cyclic change of the phase modulation.
Determines the amount by which pitch is detuned.
Selects the device for changing how to distort the sound.
Determines the spread of the selected effect.
Determines the direction of the modulation controlled by the envelope
follower.
Determines the high frequency for dividing the entire sound into three
bands.
Determines the low frequency for dividing the entire sound into three
bands.
Determines the minimum level of the portions extracted via the Slice effect.
57
Effects