Hunter 25745 Owner's Manual And Installation Manual page 12

8 • Completing Your Installation With or Without a Multi Staked Light Fixture (Cont.)
Steps 8-6 – 8-7
Lower Switch
Housing
Plug
Connector
Detail
Housing
Assembly Screw
Thumbscrews
Steps 8-8 – 8-10
8-6. To attach the lower switch housing, connect the plug connector
from the motor to the plug connector from the receiver in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only fit together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
Plug
Connector
operation and damage to the product.
8-7. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower switch
housings. Attach the lower switch housing to the upper switch
housing with three #6-32 x 1/2" housing assembly screws.
8-8. To install each shade, first loosen the three thumbscrews.
8-9. Raise the shade to the light fixture. Tighten the thumbscrews
securely.
8-10. Install B10 candelabra base light bulbs (60 Watt maximum each).
Note: Glass shade style and number of lights may vary.
Note: In compliance with US federal energy regulations, this
ceiling fan contains a device that restricts the light kit to a
maximum of 190 Watts. Exceeding that limit or the marked
limit on this product may result in fire hazard or improper
operation.
Shade
Bulb
12
42419-01 • 11/24/08 • Hunter Fan Company