Diskette Drive - Gateway GM5407H Reference Manual

Diskette drive

The diskette drive is not recognized
•
You cannot save a file to diskette or you see the message
"disk is full or write-protected"
•
•
•
•
•
You see an "Access Denied" or "Write protect" error
message
•
•
•
•
You see a "Disk is full" error message
•
•
•
You see a "Non-system disk" or "Disk error" error message
•
•
www.gateway.com
Shut down and restart your computer.
Make sure that the write-protection tab on the
upper-right corner of the diskette is down
(unprotected).
Delete unnecessary files on the diskette and try again.
Make sure that the diskette you are using is
IBM-compatible.
Try a different diskette. Occasionally diskettes are
flawed and cannot be read by the diskette drive.
Run Error-checking on the diskette. For more
information, see "Checking the hard drive for errors" on
page 68. If errors are detected and corrected, try using
the diskette again.
Move the write-protection tab in the upper-right corner
of the diskette down (unprotected).
The diskette may be full. Delete unnecessary files on the
diskette and try again.
Make sure that the diskette you are using is
IBM-compatible.
Try a different diskette. Occasionally diskettes are
flawed and cannot be read by the diskette drive.
Delete unnecessary files on the diskette.
Try a different diskette. Occasionally diskettes are
flawed and cannot be read by the diskette drive.
Run Error Checking on the diskette. For more
information, see "Checking the hard drive for errors" on
page 68.
Eject the diskette from the diskette drive, then press
E .
NTER
Make sure that the diskette you are using is
IBM-compatible.
81