Connecting The Camera To Your Computer Using The Cable - Olympus E-1 Reference Manual

Connecting the camera to your computer using the cable

Connecting the camera to your computer requires the use of the USB cable or IEEE
1394 cable. The camera's PC MODE should be set beforehand to STORAGE.
~
"PC MODE" (P. 133)
1
Insert the cable into the port on your computer.
Note
● Do not connect both the USB cable and IEEE1394 cable to the camera at the same
time.
2
Make sure that the power switch is set
OFF
to , then insert the cable into the
connector on the camera.
3
Set the camera's power switch to
● Nothing is displayed on the control panel of the
camera while it is being connected to the
computer.
11
148
Look for this mark.
Terminal
USB port
USB
IEEE1394: IEEE1394 connector
USB: USB connector
IEEE1394 (FireWire) port
IEEE1394
Smaller terminal
Smaller terminal
ON
.
Terminal
Power switch