Table of Contents
Advertisement
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a coin or
screwdriver to open the battery
cover.
3. Install 2 new "AA" (UM3/LR6)
batteries following the diagram
inside the batter y box. (The
use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
•
Install batteries correctly observing the polarity (+, -) signs to avoid
leakage.
•
Do not mix old and new batteries.
•
Do not mix batteries of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
•
Remove the batteries from the equipment when the unit will not be
used for an extended period of time
•
Always remove exhausted batteries from the equipment.
•
Do not dispose of batteries in fire.
•
Do not attempt to recharge ordinary batteries.
•
The supply terminals are not to be short-circuited.
•
Only batteries of the same and equivalent type as recommended
are to be used.
WE DO NOT RECOMMEND THE USE OF RECHARGEABLE
BATTERIES.
3
Advertisement
Table of Contents
