Bissell PowerForce Compact User Manual page 11

M
aintenance and care
Clean and replace
rotating floor brush
You should check your cleaner's rotating
floor brush and drive belt regularly for wear
or damage. You should also clean the brush
and brush ends by removing string, hair and
carpet fibers. These can wrap around the
brush and hamper its ability to effectively
clean your carpet. Also, remove any debris
that has accumulated under the brush cover.
1. Turn off vacuum and unplug from
electrical outlet.
2. Place vacuum upside down with
brush roll facing upwards.
3. Remove five screws as shown with
a small Phillips screwdriver.
4 Lift off brush cover.
5. Grasp floor brush at both ends and
lift out.
6. Clean strings, hair and other debris from
floor brush, motor pulley, and drive belt.
7. Check floor brush for worn areas and
replace if needed.
8. Check air passageway for obstructions.
Remove debris from this area.
9. When finished cleaning, reposition floor
brush and drive belt. Then replace the
brush cover and five screws.
10. Turn floor brush by hand several times
in the direction of the motor pulley. If
properly installed, drive belt will align
itself on floor brush.
w w w . b i s s e l l . c o m
3.
Five Screws
5.
9.
8 0 0 . 2 3 7 . 7 6 9 1
4.
Motor Pulley
8.
Air Passageway
11