Auto-Configuration On The Cisco Vg202 And Cisco Vg204 Voice Gateways; Restrictions For Configuring Auto-Configuration - Cisco VG204 Software Configuration Manual

Voice gateways

Hide thumbs Also See for VG204:

Hardware installation manual (50 pages)

Quick start manual (19 pages)

Manual (10 pages)

Table Of Contents

Table of Contents

Chapter 4

Configuring Voice

VG(config)# ip routing

For complete information about global configuration commands, see the Cisco IOS configuration guides

and command references.

Step 6

To configure another interface, enter the exit command to return to the

To configure the Cisco VG for voice traffic, see the VoIP references in the

Step 7

page

Step 8

To exit configuration mode and return to the enable prompt, when you finish configuring interfaces,

press Ctrl-Z. To see the current operating configuration, including any changes you just made, enter the

show running-config command:

VG# show running-config

To see the configuration currently stored in NVRAM, enter the show startup-config command at the

enable prompt:

VG# show startup-config

The results of the show running-config and show startup-config commands differ if you have made

Step 9

changes to the configuration but have not yet written them to NVRAM. To write your changes to

NVRAM and make them permanent, enter the copy running-config startup-config command at the

enable prompt:

VG# copy running-config startup-config

Building configuration. . .

[OK]

VG#

The Cisco VG is now configured to boot in the new configuration.

Auto-Configuration on the Cisco VG202 and Cisco VG204 Voice

Gateways

To configure auto-configuration on the Cisco VG202 and Cisco VG204 voice gateways, follow these

guidelines and procedures:

•

Restrictions for Configuring Auto-Configuration

The following restrictions apply to configuring auto-configuration on the Cisco VG202 and Cisco

VG204 voice gateways before connecting them to the network:

•

OL-16191-01

4-1.

Restrictions for Configuring Auto-Configuration