Table of Contents
Advertisement
Provisioning Tutorial
Basic Resync
STEP 8
STEP 9
STEP 10
STEP 1
STEP 2
STEP 3
Cisco Small Business IP Telephony Devices Provisioning Guide
The Provisioning tab in the admin/advanced page contains a number of
configurable parameters specific to provisioning. Select the Provisioning tab, and
inspect the values of the general purpose parameters GPP_A through GPP_P.
These should be empty.
To resync the test IP Telephony Device to the basic.txt configuration profile,
open the following URL from the PC browser.
Assuming the PC IP address is 192. 1 68. 1 .200:
http://192.168.1.100/admin/resync?tftp://192.168.1.200/basic.txt
This resync URL method is designed for development and testing. When it
receives this command, the IP Telephony Device at address 192. 1 68. 1 . 1 00
requests the file basic.txt from the TFTP server at IP address 192. 1 68. 1 .200. It
then parses the downloaded file and updates the GPP_A parameter with the value
12345678.
Verify that the parameter was correctly updated by refreshing the admin/
advanced page on the PC web browser and selecting the Provisioning tab on that
page.
The GPP_A parameter should now contain the value 12345678.
Logging with syslog
The IP Telephony Device sends a syslog message to the designated syslog server
when the device is about to resync to a provisioning server and after the resync
has either completed or failed. This server is identified in the web server
administration (admin/advanced, System tab, Syslog_Server parameter). It is
instructive to configure the syslog server IP address into the device and observe
the messages generated during each exercise.
Exercise
Install and activate a syslog server on the local PC.
Program the PC IP address into the Syslog_Server parameter, and submit the
change.
Click the System tab and enter the value of your local syslog server into the
Syslog_Server parameter.
Repeat the TFTP Resync operation described in the previous exercise.
3
64
Advertisement
Table of Contents
