Removing The Emi Panels - HP Integrity Superdome SX1000 User Manual

Installing the System
Setting Up the hp Integrity Superdome or hp 9000 Superdome

Removing the EMI Panels

Remove the front and back electromagnetic interference (EMI) panels to access ports and to visually check
whether components are in place and the LEDs are properly illuminated when power is applied to the system.
To remove the front and back EMI panels:
Step 1. Using a T20 Torx driver, loosen the captive screw at the top center of the front EMI panel.
Figure 2-30Removing Front EMI Panel Screw
Step 2. Use the handle provided to remove the EMI panel and set it aside.
When in position, the EMI panels (front and back) are tightly in place. Removing them takes
controlled, but firm, exertion.
Step 3. Loosen the captive screw at the lower center of the back EMI panel.
52
Front EMI Panel Screw
Chapter 2