Removing And Replacing The Rear Electromagnetic Interference (Emi) Cover; Removing The Rear Emi Cover - HP Integrity Superdome SX1000 User Manual

Removing and Replacing Components

Removing and Replacing the Rear Electromagnetic Interference (EMI) Cover

Removing and Replacing the Rear Electromagnetic Interference
(EMI) Cover
There is an EMI (Electromagnetic Interference) cover on the rear of the cabinet. This cover is secured with
one captive screw in the lower center of the cover. The screw can be seen through the hole in the lower center
of the cover. Care should be taken so as not to damage the EMI gasket on the cover. This cover is easily
removed.
Figure 3-3 Rear EMI Cover Location
EMI Cover

Removing the Rear EMI Cover

Step 1. Open the rear cabinet door.
Step 2. Loosen the single slotted T-25 captive screw in the lower center of the EMI cover.
Step 3. Using the handle on the EMI panel, tilt the cover away from the chassis at the captive screw edge.
Step 4. Remove the cover from the chassis.
86
Chapter 3