Removing The Cover Panels - HP D7171A - NetServer - LPr Installation Manual

Chapter 1

Removing the Cover Panels

The NetServer has three removable cover panels (see Figure 1-2):
Cover 1 covers the side where the I/O board is located.
Cover 2 covers the area above the processor.
Cover 3 covers the side where the processor is located.
You will remove cover 3 to access the system board and upgrade the
NetServer processor module.
CAUTION The NetServer covers are heavy. Support them as you remove
them, and allow room to move them away from the NetServer
and for storage.
1. Remove cover 3 by unscrewing the thumbscrew, pulling the cover forward
using the cover handle and then slightly sideways to disengage it.
2. Lift it up and away from the chassis.
Proceed to the section "Installing the Processor Modules" later in this chapter.
Figure 1-2. HP NetServer LH 3 Covers
Processor Module Installation
5