If Paper Misfeeds; Misfeed Location Indicators; Cautions - Kyocera KM-6230 Instruction Handbook Manual

3. If paper misfeeds

If a paper misfeed occurs, copying will stop, a message informing you of the misfeed will be displayed on the touch panel, and the location of the
misfeed will be displayed as well. Leave the main switch turned ON ( | ) and refer to "(3) Removal procedures" in order to remove the misfed paper.

(1) Misfeed location indicators

1 Misfeed in the paper feed section (page 10-5)
2 Misfeed in the paper conveyor section (page 10-7)
3 Misfeed in the fixing unit or ejection section (page 10-8)
4 Misfeed in the duplex unit (page 10-10)
5 Misfeed in the DF (page 10-11)
6 Misfeed in the optional Finisher (page 10-12)
7 Misfeed in the optional Side Deck (page 10-16)

(2) Cautions

WARNING
High voltage is present in the charger section. Take sufficient care when working in this
area, as there is a danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take sufficient care when working in this area,
as there is a danger of getting burned.
* Do not reuse misfed paper.
* If paper gets torn during removal, be sure to remove any loose scraps from inside the copier or they could cause
further misfeeds later on.
* After the misfed paper is removed, warm-up will begin, the misfeed message will disappear, and the copier will
return to the same settings as before the misfeed.
* Even if a misfeed occurs in the optional Finisher, that copy will be made again so it is not necessary to set any
misfed copies into the Sort or Non-sort trays.
Section 10 TROUBLESHOOTING
The procedure to remove misfed paper can
be displayed on the touch panel by touching
the "?" key.
10-4