The Screen Menu - Sony VPL-FX30 Operating Instructions Manual

The Screen Menu

For adjusting the size, position, and aspect ratio of the projected image for each input signal.
Setting items Description
*1
Aspect Changes the aspect ratio of the projected image. (page 18).
When the Normal: Displays the image on the center point of the projected image
computer without changing the resolution of the input signal or enlarging the image.
signal is
Full1: Displays the image to fit the maximum projected image size without
input
changing the aspect ratio of the input signal.
Full2: Displays the image to fit the maximum projected image size.
When the 4:3: Displays the image to fit the maximum projected image size with an
video signal aspect ratio fixed to 4:3.
is input 16:9: Displays the image to fit the maximum projected image size with an
aspect ratio fixed to 16:9.
Zoom: Display the center point of the projected image to zoom.
*2
Over Scan On/Off: Hides the outline of the image when set to "On." Select "On" if
noise appears along the edge of the image.
*3
Adjust Signal Adjusts the image of a computer signal. Use this item if the edge of the
image is cut and reception is bad.
*3 *4
APA Automatically adjusts the projected image to an optimum quality when you
press the ENTER key.
*3
Phase Adjusts the dot phase of the display pixel and the input signal. Set to the
value where looks clearest.
*3
Pitch The higher the setting, the wider the horizontal image elements (pitch). The
lower the setting, the narrower the horizontal image elements (pitch).
*5
Shift H: The higher the setting, the farther right the image is projected on the
screen. The lower the setting, the image farther left.
V: The higher the setting, the farther up the image is projected on the screen.
The lower the setting, the image farther down.
Notes
*1: • Note that if the projector is used for profit or for public viewing, modifying the original picture
by switching to the aspect mode may constitute an infringement of the rights of authors or
producers, which are legally protected.
• Depending on the input signal, setting items for aspect ratio or some other setting items cannot
be set in some cases, or changing the aspect ratio setting may have no effect.
• A part of the image may be displayed in black, depending on the setting item.
*2: Available when a video signal is input from the YP
input connector.
*3: Available when a computer signal is input from the RGB input connector (INPUT A, INPUT B).
*4: If the projected image includes large amount of black portion around it, the APA function will
not work properly and a part of the image may not be displayed on the screen and also optimum
image cannot be obtained, depending on the type of input signal. In this case, adjust the "Phase,"
"Pitch," and "Shift" items manually.
*5: Available when a computer signal is input from the RGB input connector (INPUT A, INPUT
B) or a video signal is input from the YP
P input connector (INPUT A) or DVI-D
B R
P input connector (INPUT A).
B R
17
The Screen Menu