Viewing A List Of Attached Devices - NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual
This screen displays the following parameters:
Table 3-1. General Information Fields
Field
Access Point Information
Access Point Mode
Access Point Name
MAC Address
Region
Firmware Version
Current IP Settings – These parameters apply to the Local WG602v3 wireless access point.
IP Address
Subnet Mask
Default Gateway
DHCP Client
Wireless Settings – These parameters apply to the target remote WG602v3, VPN gateway, or VPN client.
Wireless Network Name (SSID) Displays the wireless network name (SSID) being used by the
Associated AP (Client mode
only)
Channel
Encryption Type
Access Control

Viewing a List of Attached Devices

The Station List table contains a list of all devices associated with this wireless access point in the
wireless network defined by their Wireless Network Name (SSID). The feature is not available
when in Client Mode.
3-2
Description
Shows the current operating mode of the device: AP, Bridge,
Repeater or Client.
The default name can be changed if desired.
Displays the Media Access Control address (MAC Addresses) of the
wireless access point's Ethernet port.
Displays the country or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access
point in a region other than one of those identified in this field.
The version of the firmware currently installed.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point.
Enabled by default. Enabled (DHCP client) indicates that the current
IP address was obtained from a DHCP server on your network.
wireless port of the wireless access point. The default is NETGEAR.
The MAC address of a remote AP or peer that this wireless access
point is connected to.
Identifies the channel the wireless port is using.
The current encryption setting.
Restricts wireless access by MAC address. Disabled by default.
v1.0, August 2006
Management