Configuring Repeater With Wireless Client Association - NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual

Configuring Repeater with Wireless Client Association

In this mode, the WG602v3 will operate as a Repeater only, and send all traffic to the remote
wireless access point. You must enter the MAC address (physical address) of the remote wireless
access point.
To configure the WG602v3 in wireless repeater mode:
1. Open a web browser and log into the WG602v3 using the addressing scheme you have set up.
Figure 4-5
2. Under Advanced on the main menu, click Wireless Bridging. The Wireless Bridging screen
will display showing the default settings for the wireless access point.
3. Select the Repeater with Wireless Client Association radio button to enable Repeater Mode.
4. Enter the MAC address of the remote wireless access point and click Add. The AP's MAC
address and connection information will appear in the Wireless Remote Access Point List.
Advanced Configuration
NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual
v1.0, August 2006
4-7