NETGEAR WG311v2 - 54 Mbps Wireless PCI Adapter Installation Manual page 25

Installation Guide for the NETGEAR 54 Mbps Wireless PCI Adapter WG311 v2
Install the NETGEAR 54 Mbps Wireless
PCI Adapter WG311 v2.
Shut down the PC and remove the power
a.
cord. Insert the WG311 v2 Wireless PCI
Adapter with the NETGEAR logo facing
up into an available PCI slot.
Reconnect the power cord and reboot the
b.
computer. After a short delay, the Found
New Hardware Wizard displays.
Click Next and follow the prompts to
c.
proceed. After the installation
completes, click Finish to close the
wizard.
You should see the WG311 v2 system tray
icon on the lower right portion of the
Windows task bar.
Basic Setup
Add New Hardware Wizard
Note: If Windows displays a Digital Signature Not
Found warning, click Yes to continue.
WG311 v2 System Tray Icon
2-9