Wg311 V2 Default Wireless Configuration Settings - NETGEAR WG311v2 - 54 Mbps Wireless PCI Adapter Installation Manual

Installation Guide for the NETGEAR 54 Mbps Wireless PCI Adapter WG311 v2

WG311 v2 Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network
and verify wireless connectivity. If this is an addition to an existing wireless network, you will
need to identify the wireless configuration and security parameters already defined.
Your NETGEAR 54 Mbps Wireless PCI Adapter WG311 v2 factory default basic settings are:
• Network Name Service Set Identification (SSID):
first available network will be used
: In order for the WG311 v2 Wireless PCI Adapter to communicate with a wireless access
Note
point or wireless adapter, all devices must be configured with the same wireless network name
(SSID).
• Network Mode (Infrastructure or Ad-Hoc):
• Data security WEP encryption: Disabled
The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless PCI
Adapter WG311 v2 for basic wireless connectivity to an access point. The procedures provide
step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the
version of Windows you are using.
Basic Setup
ANY — a special name which indicates the
Infrastructure
2-3