Rf Exposure Warning For North America, And Australia - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

802.11g wireless access point
Hide thumbs Also See for WG302 - 802.11g ProSafe Wireless Access Point:
Table of Contents

Advertisement

Reorient or locate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Warning for North America, and Australia

Warning! To meet FCC and other national safety guidelines for rf exposure, the antennas for this device (see
below) must be installed to ensure a minimum separation distance of 20cm (7.9 in.) from persons. Further,
the antennas shall not be co-located with other antenna or radio transmitter.
Antenna Statement for North America and Australia
In addition to its own 2 antennas, the WG302 device has been approved for use with the following
detachable antennas and antenna cables:
Approved
Antenna Gain and
Antennas
type
NETGEAR
18 dBi, directional
ANT24D18
outdoor/indoor
NETGEAR
9 dBi, omnidirectional
ANT2409
outdoor/indoor
NETGEAR
5 dBi, ceiling/wall
ANT24O5
indoor
* WG302 maximum radiated power in North America and Australia: 20 dBm – cable loss + antenna gain
Please go to www.netgear.com/go-fcc.... for an updated list of wireless accessories approved to be used with
the WG302 in North America and Australia.
Industry Canada Compliance Statement
This Class B Digital apparatus meets all the requirements of the Canadian Interference Causing
Equipment Regulations ICES 003.
Cet appareil numerique de classe B respecte les exigences du reglement du Canada sur le materiel
brouilleur NMB-003.
The device is certified to the requirements of RSS-210 for 2.4 GHz spread spectrum devices. The
use of this device in a system operating either partially or completely outdoors may require the
user to obtain a license for the system according to the Canadian regulations. For further
Approved Antenna
Antenna Cable
Cable
Length
NETGEAR
1.5 m to 30 m
ACC-10314-01 thru
05
NETGEAR
1.5 m to 30 m
ACC-10314-01 thru
05
NETGEAR
1.5 m to 30 m
ACC-10314-01 thru
05
December 2003
Maximum
Transmitted Power
19 dBm + 18 dBi ant.
19 dBm + 9 dBi ant.
19 dBm + 5 dBi ant.
5

Advertisement

Table of Contents
loading

Table of Contents