NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 20

Reference Manual for the WG302 802.11g ProSafe Wireless Access Point
The following table explains the LED indicators:
LED DESCRIPTION
PWR Power Indicator
No power. If this LED does not come on with the power adapter and cord correctly
Off
installed, see Chapter 4, Troubleshooting.
Power is on.
On
TEST Self Test Indicator
Blink Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going on steady.
100 Ethernet LAN Speed Indicator
Off Indicates 10 Mbps Ethernet link detected
Green On 100 Mbps Fast Ethernet link detected.
LINK/ACT LAN Ethernet LAN Link Activity Indicator
Off Indicates no Ethernet link detected.
Green On 100 Mbps Fast Ethernet link detected, no activity.
Green Blink Indicates data traffic on the 100Mbps Ethernet LAN.
Amber 0n 10 Mbps Ethernet link detected, no activity.
Amber Blink Indicates data traffic on the 10Mbps Ethernet LAN.
802.11g WLAN Wireless LAN Link Activity Indicator
Off Indicates no wireless link activity.
Green Blink Wireless link activity.
2-6
December 2003
Introduction