JVC GZ-HM200AUS - Everio Camcorder - 1080p Manual Book page 64

Changing the Menu Settings
Menus
Y BASIC SETTINGS
[ DEMO MODE
Introduces special features of
the camcorder when there is no
operation for about 3 minutes during
recording mode.
( AUTO POWER OFF
If the camcorder is not operated for
5 minutes while the power is on,
it turns itself off automatically to
conserve power.
\ OPERATION SOUND
Turns on/off the operation sound.
RECORD BUTTON
Enables the recording button [REC]
on the LCD monitor.
& QUICK RESTART
Enables the camcorder to start
up quickly when you turn off the
camcorder and then on again within
five minutes by closing and opening
the LCD monitor.
]
REMOTE
Turns on/off reception of the
operation signal from the remote
control.
AUTO FINALIZE
Sets the disc to a readable state.

Settings: [ ] = Factory-preset
Select [BASIC SETTINGS], then select sub-menus.
OFF: Deactivates the function.
[ON]: Activates the function.
NOTE
•
The demonstration only works when the AC adapter is
connected, not with the battery pack.
•
If an SD card is in the camcorder, demonstration will not
take place even if this mode is set to [ON].
•
Demo mode takes precedence over Auto Power Off.
Demonstration will be performed even when [AUTO
POWER OFF] is set to [ON].
OFF: Disables the function.
[ON]: Activates the function.
To turn the camcorder on again, close the LCD
monitor and open it again when using the battery
pack. When using the AC adapter, perform any
operation such as zooming.
OFF: Turns off the operation sound.
[ON]: The melody sounds when operations are
performed.
OFF: Deactivates the function.
[ON]: Activates the function.
OFF: A quick start is not performed.
[ON]: If the LCD monitor is opened again within 5 minutes,
the camcorder starts quickly. The power consumption
used for the 5-minute period after the LCD monitor
is closed is approximately 1/3 of that used during
recording. This enables you to save more power than
leaving the power on.
OFF: Does not receive the signal from the remote control.
[ON]: Enables operation with the remote control.
OFF: Makes created discs recordable (not playable on
device other than the camcorder).
[ON]: Finalizes created discs so that they can be played
back on BD/DVD burner.
NOTE
•
When you play back a disc created when [OFF] is set on
BD/DVD burner, select [FINALIZE] on the disc creation
screen. (Z p. 49)
•
When you create two or more discs at the same time,
other than the last disc is finalized automatically even if the
setting is [OFF].
(Continued)