Using The Feature (Depending On The Model) - Samsung UW-17J11VD Owner's Instructions Manual

C18A_ENG_europe_17"_film
Using the
Before presetting your VCR unit:
Check that the language, date and time are correct
(if the clock has not been set, the Date/Time Setting
function is activated automatically)
Insert the cassette on which the programme is to be
recorded (safety tab intact)
Up to six programmes can be preset.
1
Press the SHOW VIEW button.
Result: A message is displayed to allow you to enter the
SHOWVIEW code.
If there is no SHOW VIEW button on your remote control,
the SHOWVIEW feature is not available on your model. If all
six programmes have been set, the list of preset recordings
is displayed to enable you to modify an existing recording or
clear one that you no longer require. Refer to page 51 for
further details.
2
Press the numeric buttons to enter the code opposite the
programme that you wish to record in your television magazine.
If you wish to correct the SHOWVIEW code that you are
entering:
Press the œ button until the digit to be corrected is
cleared
Enter the correct digit
3
Press the MENU button.
Result: The Timer Record is selected.
4 Press the œ or √ button again.
When you finish the inputting SHOWVIEW code, the Timer
Record program will be set automatically. At this moment,
the current channel is set for the recording. The channel to
be recorded should be selected by user.
Press the † or ... button to select Start, and tnen press the œ or
5
√ button. Modify the start time by pressing the † or ... button.
When entering the date and time, all single digits must be
preceded by a zero.
Example: 7:30 am
6 Press the † or ... button to select Stop. Modify the stop time in
the same way.
To set Record Stop time to less than one hour, always
select Minute first.
10/14/03 9:34 AM Page 47
Feature
(depending on the model)
Enter 07:30
SHOWVIEW
CODE - - - - - - - - -
0-9 Code Correct End
VCR Menu
√
Timer Record
√
Timer Record Review
Repeat : Off
Picture : Normal
Tape Select : E180/T120
V.System : AUTO
Select Enter Exit
VCR Menu
PR. P 1
Start 22 : 00
Stop 23 : 00
Date 30 / 04 / 2003
Mode Once
Decoder Off
Speed SP
PDC Off
Select Adjust Exit
VCR Menu
PR. P 1
Start 22 : 00
Stop 23 : 00
Date 30 / 04 / 2003
Mode Once
Decoder Off
Speed SP
PDC Off
Select Adjust Exit
VCR Menu
PR. P 1
Start 22 : 00
Stop 23 : 00
Date 30 / 04 / 2003
Mode Once
Decoder Off
Speed SP
PDC Off
Select Adjust Exit
47
ENG