Using The Tv Buttons On The Remote Control; Stereo Connections - Samsung DVD-V540 Instruction Manual

Using the TV Buttons on the
Remote Control
Your VCR remote control will work with Samsung
televisions and compatible brands.
To determine whether your television is compatible,
follow the instructions below.
1 Switch your television on.
2 Point the remote control towards the television.
3 Hold down the TV button and enter the two-figure
code corresponding to the brand of your television,
by pressing the appropriate numeric buttons.
Brand Codes
SAMSUNG 01, 14, 15, 23, 31 LOEWE
SHARP 02, 16, 22
SONY 03
RCA 07, 29
TOSHIBA 09
PANASONIC 12, 24
HITACHI 10
NEWSAN 27
JVC 11
MITSUBISHI 13
Result: If your television is compatible with the
remote control, it will switch off. It is now
programmed to operate with the remote
control.
If several codes are indicated for your television brand,
try each one in turn until you find one that works.
You can then control the television using the following buttons.
Button Function
POWER Used to switch the television on and
off.
INPUT SEL. Used to select an external source.
VOL + or – Used to adjust the volume of the
television.
CH ( or ) Used to select the required channel.
TV MUTE Used to toggle the sound on and off.
The various functions will not necessarily work on all
televisions. If you encounter problems, operate the
television directly.
Brand Codes
28
ZENITH 17
LG 06, 08, 18
MAGNAVOX 04
EMERSON 21
SANYO 05, 20
DAEWOO 19
NOBLEX 25
TELEFUNKEN 26
GRADIENT 30

Stereo Connections

You can connect your DVD-VCR to your home stereo
system or stereo TV and enjoy stereo sound when
watching a movie or TV.
1 Connect DVD-VCR to Stereo
Using RCA cables, connect the Line Out Left and
Right Audio jacks on the rear panel of the DVD-VCR
to the Aux Input on your stereo receiver.
Connect the Video Output also in case you are using
a stereo TV.
2 Set Stereo to Auxiliary Mode
Set your stereo receiver or TV to either "Aux" or
"Tape" regardless of which line input you are using for
your particular device.
3 Play a Tape
Insert a DVD or Hi-Fi stereo videotape into your
DVD-VCR. Be sure to adjust the volume on your
stereo receiver or TV. Audio will be heard through
your stereo speakers
• If there is no stereo sound even after you have
inserted a Hi-Fi stereo videotape, press the AUDIO
button until "Hi-Fi" appears on the on-screen display.
ENG-8