Adjusting The Lcd During Play; Controlling Sound From The Speaker - Samsung VP-D97I Owner's Instruction Book

ENGLISH
Basic Recording

Adjusting the LCD during PLAY

You can adjust the LCD during playback.
The adjustment method is the same procedure as used in CAM mode. (see page 31)

Controlling Sound from the Speaker

The Speaker works in PLAYER mode only.
When you use the LCD screen for playback, you can hear recorded sound from
the built-in Speaker.
- Follow the instructions below to decrease or mute speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or mute the sound while playing a tape
on the camcorder.
1. Set the power switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play, use the MENU SELECTOR to adjust the
volume.
A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between 00 to 19. You will not hear
any sound when the volume is set on 00.
If you close the LCD while playing, you will not hear sound from the speaker.
Notes
When the cable is connected to the Multi AV jack, you cannot hear sound from the speaker
and cannot adjust the volume.
If a cable is connected to the Multi AV jack, you can hear sound from the speaker when
AV IN/OUT MODE on MENU is set to AV IN or S-VIDEO IN. (VP-D93i/D97i/D99i only)
You can hear sound from speaker by removing the connected cable from the Multi AV jack.
The speaker turns off when you use earphones.
34 34
2
3-1
VOLUME
<3-2>
0 : 2 3 : 4 7
5 5 min
VOL. [ 1 1 ]
1 0 : 0 0
10 . J A N . 2 0 0 3