Adjusting The Lcd During Play; Controlling Sound From The Speaker - Samsung SCD5000 Owner's Instruction Manual

Preparation

Adjusting the LCD during PLAY

✤ You can adjust the LCD during playback.
✤ The adjustment method is the same as is used while in CAMERA mode. (See page 31)

Controlling Sound from the Speaker

The Speaker only works in PLAYER mode.
I
When you use the LCD screen for playback, you can hear the recorded sound from
the built-in Speaker.
- Follow the instructions below to decrease or mute speaker volume in PLAYER mode.
- Take the following steps to lower the volume or mute the sound while playing a tape
on the camcorder.
1. Set the device to CAMCORDER and set the Power Switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3. Once the tape is in play and you hear sound, use the MENU DIAL to adjust the volume.
I
A Volume Level display will appear on the LCD.
Levels may be adjusted from anywhere between 0 to 19. You will not hear
any sound when the volume is set on 0.
I
If you close the LCD while playing, you will not hear sound from the speaker.
Notes
I
When the cable is connected to the A/V jack, you cannot hear sound from the speaker and
cannot adjust the volume.
I
You can hear sound from the speaker by removing the connected cable from the A/V jack
ENGLISH
FADE
S.SHOW
BLC
DELETE
REV FWD
<3-2>
0 : 2 3 : 4 7
5 5 min
VOL. [ 1 1 ] 1 2 : 0 0 AM
O C T . 1 0 . 2 0 0 3
35 35