Installing / Removing The (Optional ) Battery Pack - Kenwood TK-2180 Instruction Manual

I / R
NSTALLING
1 Align the battery pack with the
back of the transceiver, then
press the battery pack and
transceiver firmly together
until the release latch clicks,
locking it in place.
2 Flip the safety catch into place
to prevent accidentally
pressing the release latch and
removing the battery.
3 To remove the battery pack,
lift the safety catch on the
base of the transceiver, then
press the release latch
underneath the safety catch
while pulling the battery pack
away from the transceiver.
Note:
To lift the battery pack safety catch, use a piece of hardened
plastic or metal, such as a screwdriver, that is no more than
6 mm wide and 1 mm thick. It is imperative that you place the
implement under only the lip of the safety catch so that you do
not damage the release latch.
Before charging a battery pack that is attached to the transceiver,
ensure that the safety catch is firmly closed.
While operating the transceiver using a Li-ion or Ni-MH battery
pack in areas with an ambient temperature of +14°F/ –10°C and
lower, operating time may be shortened.
EMOVING THE
(O ) B
PTIONAL
P
ATTERY ACK
7