Safety Precautions - Kenwood KTC-9090DAB Instruction Manual

Safety precautions

2WARNING
To prevent injury and/or fire, take the
following precautions:
• Insert the unit all the way until it is fully locked in
place. Otherwise it may fly out of place during
collisions and other jolts.
• To prevent short circuits, never put or leave any
metallic objects (e.g., coins or metal tools) inside the
unit.
• If the unit starts to emit smoke or strange smells,
turn off the power immediately and consult your
Kenwood dealer.
• Be careful not to drop the unit or subject it to strong
shock.
2CAUTION
To prevent damage to the machine, take the
following precautions:
• Do not open the top or bottom covers of the unit.
• Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of water
splashing.
• During installation, do not use any screws except for
the ones provided. The use of improper screws might
result in damage to the main unit.
• When drilling a hole in the car to fix the brackets,
make sure not to damage the fuel tank, brake tube,
wiring harnesses, etc. on the other side.
NOTE
• If you experience problems during installation,
consult your Kenwood dealer.
• If the unit does not seem to be working right, try
pressing the reset button on the control unit first.
If that does not solve the problem, consult your
Kenwood dealer.
Cleaning the Unit
If the front panel is dirty, wipe it clean with a silicon
cloth or soft dry cloth with the power off.
2CAUTION
•
Do not use hard cloths or paint thinner, alcohol, or other
volatile solvents. These may damage external surfaces or
remove indicator characters.
IMPORTANT INFORMATION
About the disc changer to be connected:
Kenwood disc changers/ CD players released in 1998
or later can be connected to this unit.
Note that any Kenwood disc changers/ CD players
released in 1997 or earlier and disc changers made by
other makers cannot be connected to this unit.
Unsupported connection may result in damage.
Setting the "O-N" Switch to the "N" position for the
applicable Kenwood disc changers/ CD players.
3
|
English