Installation Procedure - Kenwood KTC-9090DAB Instruction Manual

Installation Procedure

1. To prevent short circuits, remove the key from the
ignition and disconnect the - terminal of the
battery.
2. Install the DAB antenna and connect the antenna
cable to the DAB hideaway tuner.
3. Connect the DAB hideaway tuner and the control
unit using the provided DAB connection cable.
4. Make the proper input and output cable
connections for each unit.
5. Install the unit in your car.
6. Reconnect the - terminal of the battery.
7. Press the reset button on the control unit.
2CAUTION
• Do not connect the DAB control cable whilst the control unit
is turned ON.
• Be sure to press the reset button on the control unit after
installation.
• If your car is not prepared for this special connection-system,
consult your Kenwood dealer.
• Make sure that all cable connections are securely made by
inserting jacks until they lock completely.
• Do not let unconnected cables or terminals touch metal on
the car or anything else conducting electricity. To prevent
short circuits, also do not remove the caps on the ends of
the unconnected cables or the terminals.
• Insulate unconnected cables with vinyl tape or other similar
material.
• Be sure to use the provided DAB antenna (Accessory 7, 8)
as the DAB antenna. Using other antenna than provide may
lead to malfunction.
• Take care so that the antenna cable and other connection
cables are not caught by mobile parts. Otherwise cable
disconnection or other trouble may result.
• Do not apply too much force on the antenna cable, other
connection cables and connectors by bending a cable, etc.
Otherwise cable disconnection or other trouble may result.
• Securely fasten the screws that fix the DAB antenna as well
as the screws of the DAB antenna itself. Screws that loosen
introduce the danger of the antenna coming apart during
travel.
• DC voltage is output from the DAB antenna terminal of
the DAB hideaway tuner to supply power to the DAB
antenna. Be sure to connect the supplied DAB antenna only.
Otherwise, the unit may be damaged.
• After the unit is installed, check whether the brake lamps,
indicators, wipers, etc. on the car are working properly.
25
|
English