Security Code; Source Select Mode; Ipod Mode Setting - Kenwood KDC-X8006U Instruction Manual

In Standby mode

Security Code

Activating the Security Code disables the usage
of audio unit by someone else. Once the Security
Code is activated, the entry of authorized Security
Code is required to turn on the audio unit when it is
removed from the vehicle. Indication of this Security
Code activation prevents your precious audio unit
from stealing.
⁄
• When you activate the Security Code function, it cannot be
released.
Note, your Security Code is the 4 digit number entered in
your "Car Audio Passport" in this package.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
Refer to <Selecting the Source> (page 6).
2
Enter Menu mode
Using the Control knob, select "MENU".
For the operation method, refer to <Function
Control mode> (page 10).
"Security Set" is displayed.
3
Enter Security Code mode
Press the Control knob for at least 1 second.
When "Enter" is displayed, "SECURITY SET" is also
displayed.
4
Select the digits to enter
Push the Control knob towards right or left.
5
Select the Security Code numbers
Turn the Control knob or push it towards up or
down.
6
Repeat steps 4 and 5, and complete the
Security Code.
7
Confirm the Security Code
Press the Control knob for at least 3 seconds.
When "Re-Enter" is displayed, "SECURITY SET" is also
displayed.
8
Do the step 4 through 7 step operation, and
reenter the security code.
"Approved" is displayed.
The Security Code function activates.
⁄
• If you enter a Code different from your Security Code,
you have to start over from step 4.
9
Exit Security Code mode
Press the [FNC] button.
Resetting the Security Code function when the
audio unit is first used after removed from the
battery power source or the Reset button is
pressed
1
Turn the power ON.
2
Do the step 4 through 7 step operation, and
reenter the security code.
"Approved" is displayed.
Now, you can use the unit.
⁄
• If an incorrect code is entered, "Waiting" is displayed, and
the input prohibition periods shown in the table below
is generated.
After the input prohibition time lapses, "SECURITY SET" is
displayed, and you can reenter the code.
Number of times the
incorrect code was input
1
2
3
4
In Standby mode

Source Select Mode

Setting up the Source Select mode.
Display Setting
"SRC Select : 1" Displays source icons for your choice.
"SRC Select : 2" Allows you to select sources one after another.
In USB mode with iPod connected

iPod mode setting

Setting up the iPod operation method in File Select.
Display Setting
"iPod Mode : ON" Uses the operation method similar to that of
iPod.
"iPod Mode : OFF" Uses the operation method different from that
of iPod.
Input prohibited time
—
5 minutes
1 hour
24 hours
|
English
25