Clifford Matrix 2.2X Owner's Manual page 29

p p o o w w e e r r s s a a v v e e r r m m o o d d e e
Your system will automatically enter Power Saver Mode while
armed or in Valet
operation has been performed. This lowers the current draw to
the vehicle's battery. Power Saver Mode takes over under the
following conditions:
Power Saver when the system is armed: After the system has
been armed for 24 hours, the in-vehicle LED will flash at
half its normal rate, decreasing the system's current draw.
Power Saver in Valet
Mode the in-vehicle LED illuminates steadily. If the vehicle
is not used (ignition is not turned on) for a period of one
hour while the system is in Valet
off. If the system remains in Valet
come back on the next time the ignition is turned on and
then back off.
p p r r o o g g r r a a m m m m i i n n g g o o p p t t i i o o n n s s
Programming options control what your system does during
normal operation, and require few or no additional parts.
However, some may require additional installation labor.
The following is a list of the program settings, with the factory
settings in B B o o l l d d : :
26
® Mode, after a period of time in which no
Mode: When the system enters Valet
®
Mode, the LED will shut
®
Mode, the LED will
®
© 2004 directed electronics, inc.
®