TRANSMITTER PROGRAMMING
IGN
OFF
WAIT FOR
(BLUE WIRE GROUNDED)
4 FLASHES
PRESS 4X's
IGN
OFF
START
FLASH 2, 3, or 4 X's
2 VEHICLE OPERATION
A single CS2011RS III remote can control two independent vehicles
with CS2011 RS III systems installed.
CAR I / CAR II OPERATION
SETUP:
See diagram at right on how to switch your remote control to Car II
operation. Once you have switched your remote to Car II, then follow
CAR I
the transmitter programming steps AT VEHICLE II and learn YOUR
remote, along with Car II's existing remotes. Transmitter programming
Slide
steps are listed page 10 with a diagram above.
START
CAR II
RS 900 V