Fxo Timer Values (Sec) Section (Spa8800) - Cisco Small Business SPA2102 Administration Manual

ATA Voice Field Reference
Line page
Cisco Small Business ATA Administration Guide
Line 1 Signal Hook
Flash to PSTN
PSTN CID Name
Prefix
Voice tab > Line page >

FXO Timer Values (sec) section (SPA8800)

PSTN Answer
Delay
PSTN-To-VoIP Call
Max Dur
VoIP-To-PSTN Call
Max Dur
VoIP DLG Refresh
Intvl
PSTN Ring Timeout Delay after a ring burst before the SPA decides that PSTN
The operation of the hook flash on the analog phone when
a PSTN-to-VoIP call is active.
Choose Disabled or Double Hook Flash.
The default is Disabled.
The prefix to add to the caller ID name that is sent to the
PBX.
Enter the characters to add to the caller ID name.
Delay in seconds before auto-answering inbound PSTN
calls after the PSTN starts ringing. The range is 0-255.
The default is 16.
Limit on the duration of a PSTN-To-VoIP Gateway Call. Unit
is in seconds. 0 means unlimited. The range is 0-
2147483647.
The default is 0.
Limit on the duration of a VoIP-To-PSTN Gateway Call. Unit
is in seconds. 0 means unlimited. The range is 0-
2147483647.
The default is 0.
Interval between (SIP) Dialog refresh messages sent by
the SPA to detect if the VoIP call-leg is still up. If value is set
to 0, SPA will not send refresh messages and VoIP call-leg
status is not checked by the SPA. The refresh message is a
SIP ReINVITE and the VoIP peer must response with a 2xx
response. If VoIP peer does not reply or response is not
greater than 2xx, the SPA will disconnect both PSTN and
VoIP call legs automatically. The range is 0-255.
The default is 30.
ring has ceased. The range is 0-255.
The default is 5.
B
184