Gateway Accounts Section (Spa3102) - Cisco Small Business SPA2102 Administration Manual

ATA Voice Field Reference
Line page
Cisco Small Business ATA Administration Guide
Fax Tone Detect
Mode
FAX Tone Detect
Mode
Symmetric RTP

Gateway Accounts section (SPA3102)

Gateway1/2/3/4
If you want the Gateway to detect the fax tone whether the
Gateway is a caller or callee, then select caller or callee. If
you want the Gateway to detect the fax tone only if the
Gateway is the caller, then select caller only. If you want
the Gateway to detect the fax tone only if the Gateway is
the callee, then select callee only.
This parameter has three possible values:
• caller or callee - SPA will detect FAX tone whether it
is callee or caller
• caller only - SPA will detect FAX tone only if it is the
caller
• callee only - SPA will detect FAX tone only if it is the
callee
The default is caller or callee.
(SPA3102) Enable symmetric RTP operation. If enabled,
the SPA3102 sends RTP packets to the source address
and port of the last received valid inbound RTP packet.
If disabled (or before the first RTP packet arrives),
the SPA3102 sends RTP to the destination as indicated
in the inbound SDP.
The default is yes.
The first of 4 gateways that can be specified to be used in
the <Dial Plan> to facilitate call routing specification (that
overrides the given proxy information). This gateway is
represented by gw1 in the <Dial Plan>. For example, the
rule 1408xxxxxxx<:@gw1> can be added to the dial plan
such that when the user dials 1408+7digits, the call will be
routed to Gateway 1. Without the <:@gw1> syntax, all calls
are routed to the given proxy by default (except IP dialing).
The default is blank.
B
179