Network Configuration - Dell PowerEdge C1100 Use Instructions

Network Configuration

NOTE:
To change any of the settings on the Network Configuration page, you must have permission to
configure iBMC.
Table 1-17. Common Settings
Settings
Register iBMC on DNS
DNS iBMC Name
Use DHCP for DNS Domain
Name
DNS Domain Name
Table 1-18. IPv4 Settings
Settings
IPv4 Enabled
DHCP Enabled
IP Address
Gateway
Subnet Mask
Use DHCP to obtain DNS server
addresses
Preferred DNS Server
Alternate DNS Server
NOTE:
The Dell Remote Management Controller is fully IPMI 2.0 compliant. You can configure the Dell
Remote Management Controller IPMI using your browser or by using an open source utility, such as
ipmitool.
18
Using the Baseboard Management Controller
Description
When checked, register this address with the Domain Name Server
(DNS).
Name to use when registering with DNS.
Enable / disable acquisition of DNS from DHCP .
Domain name to be used if it was not acquired from DHCP .
Description
If NIC enabled, this selects IPv4 protocol support, and the other fields
in this section to be enabled.
Enable / disable using DHCP for this function.
Use this IP address.
Setup the gateway of the iBMC.
Subnet mask
Enable / disable using DHCP for this function.
Specify the IP address of the preferred DNS server.
Specify the alternative IP address to be used when the preferred DNS
server is not available.