Table of Contents
Advertisement
Dinion2X
4.4
Lens mounting
The camera accepts CS-mount lenses. C-mount lenses can be
mounted using the lens adapter ring. DC-iris lenses are
recommended for the best picture performance. The camera
automatically detects the type of lens used and optimizes
performance accordingly. A spare male lens connector is
provided.
CAUTION!
To avoid damaging the CCD sensor when using a C-mount lens,
!
make sure the supplied lens adapter ring is mounted onto the
camera before mounting the lens.
Lenses weighing more than 0.5 kg (1.1lbs) must be separately
supported.
Figure 4.5 Mounting a lens
Pin
Video iris lens
1
Supply (11.5V ±0.5, 50mA max.)
2
Not used
3
Video signal 1Vpp 1kOhm
4
Ground
Note
If a short circuit is detected on the lens connector, the on-
screen display (OSD) failure message LENS SHORT CIRCUIT is
shown. The lens circuit is automatically disabled to avoid
internal damage. Remove the lens connector and check the pin
connections.
Bosch Security Systems
Connection and mounting | en
Bosch
DC iris lens
Damp -
Damp +
Drive +
Drive -
Installation Manual
Bosch
Figure 4.6 Lens connector
AR18-08-B013 | v1.0 | 2009.03
17
Hide quick links:
Advertisement
Table of Contents
