Battery Installation And Charging - AT&T TL92270 User Manual

Getting started

Battery installation and charging

Install the battery as shown below.
Step 1
Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
color-coded label. Insert the supplied
battery with the label THIS SIDE UP
facing up as indicated.
CHARGE light
To replace the battery, press the tab and slide the
battery compartment cover downwards. Lift out the old
battery and disconnect it from the handset. Follow the
instructions above to install and charge the new battery.
IMPORTANT INFORMATION:
1. Use only the supplied rechargeable battery or replacement battery (model BT166342). To
order, visit our website at
3111
. In Canada, dial
2. If you do not use the handset for a long time, disconnect and remove the battery to prevent
possible leakage.
Step 3
Charge the handset by placing it face up
in the telephone base or charger. The
CHARGE light is on when charging.
After you install your telephone or power
returns following a power outage, the
handset will prompt you to set the date
and time. For instructions, see
Set date/time on page 30. To skip setting
the date and time, press OFF/CLEAR.
www.telephones.att.com
1 (866) 288-4268
Step 2
Align the cover flat against the
battery compartment, then slide it
upwards until it clicks into place.
.
8
SET DATE
--/--/--
MM/DD/YY
SET TIME
--:-- --
1 (800) 222-
or call