Table of Contents
Advertisement
ANSWERING SYSTEM OPERATION
At Cordless Handset or Touch Tone Phone
Voice Help Menu
The Voice Help Menu allows you to use the answering system from your
cordless handset or from a remote touch tone telephone, even if you do
not know or remember the various command codes. Once you have
connected with the answering system, press 5. The system announces a
list of operations and the buttons you need to press. At the end of the list,
the system beeps twice to indicate it is ready to accept a command. You
can access the Voice Help Menu any time after the system has given you
the two-beep signal that it is ready to accept a command.
Remote Access Commands
Playing Messages
1
Connect with the answering system.
2
After the two beeps, wait four seconds. The system plays back
messages in Mailbox 1
— OR—
Press and release 1, then enter a mailbox number (1 or 2), to
play all messages in that mailbox
— OR—
Press and release 2, then enter a mailbox number (1 or 2) to
play only new messages in that mailbox.
To repeat a message, press and release 4 while the message is
3
playing. Each time you press and release 4, the system backs up
one more message.
If you're calling from a touch tone phone that sends a continuous
tone when you hold down a button, you can repeat part of a
message by pressing and holding 4. Release 4 to resume playing.
To skip a message, press and release 6 while the message is
playing. Each time you press and release 6, the system advances
one more message.
If you're calling from a touch tone phone that sends a continuous
tone when you hold down a button, you can skip part of a
message by pressing and holding 6. Release 6 to resume playing.
To stop message playback, press 5.
To save messages, hang up.
To play messages in another mailbox: After playing messages
in one mailbox, the system announces "End of messages" and
beeps twice. You can then press 1 (all messages) or 2 (new
messages only) and enter the number of the other mailbox.
33
Advertisement
Table of Contents
