Installing The Foot Switch; Installing The Programmer Box; Installing The Programmer - Brother BAS-364E Instruction Manual

6. Installing the foot switch

Do not connect the power cord until installation si compleate, otherwise the machine may operate if the foot
switch is depressed by mistake, which could result in injury.
w

7. Installing the programmer box

w
i
y
e
q

8. Installing the programmer

q
e
CAUTION
q
e
u
r
t
w
BAS-364E, 366E, 370E, 375E
Be sure to attach the connector e of the foot switch w to
the connector q whose cord comes from the center of
the front cover at the bottom of the machine.
1. Attach the programmer box q to the needle plate
support w using the screws.
2. Be sure to attach the two connectors r and t to the
respective receptacles on the rear of the floppy disk
drive y.
3. Attach the connector u to the side of the programmer
box q using the two screws i.
1. Insert the cord q of the programmer into the connector
w below the needle plate.
2. The programmer can be placed inside the box e.
Chapter 3 INSTALLATION
6