Install From Pxe; Integrity Servers Supporting Pxe/Wds Installations - HP Integrity rx7620 Installation Manual

c. In the Confirm Selection screen, click Install.
d. When the installation finishes, click Close to exit back to the Initial Configuration Tasks
screen. Then click Close again.
e. Restart the system.
NOTE:
ServerManagerCmd.exe -install SNMP-Service, and then restarting the system.
With this method you must still configure the service, as described in the next step.
31. After the system restarts, configure SNMP by completing the following steps:
a. From the Windows Desktop, select Start > Administrative Tools > Services.
b. In the Services window, right-click SNMP Service and click Properties.
c. In the Properties window, click on the Security tab.
d. In the Security tab, click Add to add a Community string. Name the string and assign
it access rights depending on your system requirements.
e. Click Apply, and then OK twice to apply the change.
f. Exit the Services window.
32. Installation of the OS is complete.
After installing the operating system, perform these tasks next:
• "Install the Integrity Support Pack (ISP)" (page 61)
• "Activate the OS" (page 50)
• "Apply OS Updates Using the Smart Update Media" (page 53)
• "Enable Windows Components" (page 54)
• "Verify System Device Drivers and Register for Updates" (page 55)
• See if you need to perform any additional tasks described here:
Issues" (page 56)
Then go to the sections describing configuration of the management tools, and perform these
tasks:
• "Configure System Management Homepage" (page 64)
• "Configure the Management Agents" (page 66)
• "Verify Installation of the nPartition Management Tools" (page 72)

Install from PXE

When a PXE-enabled client connected to the network boots up, the computer initiates a network
service request. A DHCP discover packet is sent to the network requesting the IP address of an
available WDS server. The DHCP server responds to the request by providing an IP address to
the client. Any available WDS server can respond with its IP address, and the name of the boot
file the client should request if the client selects that WDS server for service.
Support for PXE/WDS installations is limited to the HP Integrity servers listed in the following
table.
Table 2-1 Integrity servers supporting PXE/WDS installations
Server
rx2660, rx3600, rx6600, BL860c, BL870c, rx7620, rx7640,
rx8620, rx8640
Superdome (sx1000 and sx2000)
To install Windows Server 2008 from PXE, complete the following steps:
1. From EFI, select the Boot Manager.
Another way to install SNMP is from the command prompt, by entering:
"Miscellaneous Installation
PXE/WDS support
Yes
Yes
Install from PXE 45